🏸 Fiat Doblo 1.3 Multijet Wont Start

The 105bhp 1.9 8v multijet in the Doblo has a fixed geometry turbo and therfore no DPF fitted ,the same for earlier 75bhp 1.3 16v multijet versions with fixed geometry turbos. The later 85bhp 1.3 16v multijet and 120bhp 1.9 8v multijet versions have a variable geometry turbo ( VGT ) allowing for the increases in power both these engine units Nov 28, 2013. #1. Anyone shed some light on fault. Refused to start this afternoon and got mate to tow it Started within length of it self no problem. Left it running outside for 30mins to try and make sure battery has life in it for the morning just went out and switched it off Tried to restart it and it just refuses to start (Turns over well FIAT DOBLO 1.3 JTD Multijet Wont Start At All Dear All I am hoping that one person on this planet can help me start this 1.3 jtd multijet ex Post office van on a 06 reg. It all started when the clutch went one morning. I fitted a new clutch put it all back together and it would not start. Preston. Mar 21, 2010. #4. promp reply! this is the fiatforum, best fiat site on the net your welcome. yep the water/ice of the harsh winter can cause this, slip of the alternator belt and try to start it. Alternator is swine to changei put up some info on it in this section awhile back. Last edited: Mar 21, 2010. Start date Dec 25, 2012; Currently reading: General Fiat doblo 1.3 multijet. 2013. Sparkyboy123; Aug 4, 2023; The internet's #1 online community and oracle 2-press the gas pedal and hold it, 3-press the brake pedal 7 times without relesing the gas pedal, 4-keep pressing the gas pedal for 60sec. 5-Release the gas pedal and turn of the ignition key, 6- Wait for 60sec. Then turn on the ignition key and start the engine. Check if the service/oil change light turned off. I have a 2012 fiat doblo 1.3 multijet van. I cant seem to get it running i dont seem to have any power from the filter housing unit and no fuel to the fuel pump !!!!! i have tried everything i can think of checked fuses replaced relays even put new filter housing unit on i dont know where else to look please someone help me before this van Aug 27, 2019. #1. The vehicle is a 2006 1.3 multijet WAV. I need to bleed the clutch slave cylinder, as the peddle ia a little soft. I just purchased the vehicle and I'm getting it ready for the annual road test. The cylinder has a nipple but unfortunately no place to attach a spanner to loosen it. Hope you can help me out. 1INKom4.

fiat doblo 1.3 multijet wont start